Expansion cards and backup units
V
CAUTION!
Make sure that the connector side with the three dots is on the top (see
close-up). Otherwise you risk short-circuits.
9.5.3.3
Installing the BBU in the holder
Figure 115: Installing the BBU in the BBU holder
Ê At a slight angle, fit the BBU under the right retaining bracket on the BBU
holder (1).
Ê Fold down the BBU until it locks in place (2).
9.5.3.4
Installing the BBU holder into the chassis
Ê Install the BBU holder into the chassis as described in section
FBU holder into the chassis" on page
9.5.3.5
Connecting the BBU cable to a controller
Ê If applicable, install a RAID controller as described in section
expansion cards" on page
Ê Connect the BBU cable to the RAID controller.
198
175.
Upgrade and Maintenance Manual
194.
"Installing the
"Installing
TX1330 M1