Installing The New Fbu; Concluding Steps - Fujitsu Server PRIMERGY TX1330 M1 Upgrade And Maintenance Manual

Figure 119: Removing the FBU from the holder
Ê At a slight angle, slide the FBU from under the retaining brackets of the
holder and remove it.
9.5.6.3

Installing the new FBU

Ê Install the FBU as described in section
9.5.6.4

Concluding steps

"Installing the fan module" on page 152
Ê
"Reassembling" on page 58
Ê
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
Ê If applicable, "Updating RAID controller firmware" on page 80
"Enabling SVOM boot watchdog functionality" on page 84
Ê
TX1330 M1
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing an FBU" on page 189.
205