Adjustment Of Clearance Between Stapler And Fd Stopper - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 4.0 Jan. 2008
7.4

Adjustment of clearance between stapler and FD stopper

NOTE
Make this adjustment after any of the following procedures has been performed.
• When stapler fails to move appropriately.
A
[2]
[2]
[1]
[1]
9J08F3C506DA
9J08F3C507DA
7. Mechanical adjustment
1. Check the clearance between the
stapler unit [1] and the FD stopper
[2] is within the specified range.
Specification A: 2.0 mm ± 0.5 mm
2. If the value does not fall within the
specified range, make the adjust-
ment as shown below.
3. Remove the tray unit.
See P.25
4. Remove the finisher unit.
See P.28
5. Remove the finisher unit rear cover.
See P.20
6. Loosen the screw [1] and move the
mounting plate [2] to adjust.
65