Brake Cable Adjustment - Nilfisk-ALTO FLOORTEC R 870 Service Manual

Service Manual – Floortec R 870
Brake Cable Disassembly/Assembly (Continues)
Assembly
10 Assemble the components in the reverse order of disassembly, and note the following:
• Adjust the brake according to the following procedure

Brake Cable Adjustment

1 Ensure that the machine cannot move by placing opposite wedges on the rear wheels
2 Steer the front wheel to the right, about 90°, so that the brake system becomes accessible.
3 Loosen the locknut (A) and the nut (B)
4 Turn the nut (B) until the distance between the braking masses (C) and the brake disc (D) is 0 5 mm (as
shown in the figure).
5 Tighten the locknut (A) with the nut (B)
6 Remove the wedges from the rear wheels
7 Check the proper adjustment of the brake cable (E) by pushing the machine manually (do not apply the
brake)
8 Before starting to operate on the braking masses, check that the stroke of the brake pedal (F) is 1/3 or
less of the total stroke (G)
9 Perform brake tests and check the proper operation of the service and parking brake
0,5 mm
0,02 in
E
B
C
D
G
D
C
A
C
Wheel System, Traction
1/3
G
216
F
P200213