Nilfisk-ALTO FLOORTEC R 870 Service Manual page 109

Service Manual – Floortec R 870
Engine Oil Level Check
Caution! Running the engine with a
low oil level can damage the
engine itself.
Note: The oil alert system will
automatically stop the engine
before the oil level goes down
under the safety limit. To avoid
a sudden engine stop, always
check the oil level before each
start-up.
1 Drive the machine on a level ground and engage
the parking brake
2 Turn the ignition key to "0"
3 Open the engine compartment hood with the
handle and fasten it with the support rod
4 Lift and disassemble the right side bulkhead
5 Remove the oil filler plug/dipstick (A) and clean
it
6 Insert the oil filler plug/dipstick in the filler neck
(B), but do not tighten it, then remove it to check
the oil level
7 If the oil level is near or under the lower limit
mark (C) on the dipstick, top up with the
specified oil up to the upper limit mark (D)
(lower edge of the oil filling hose). Do not overfill.
8 Install the oil filler plug/dipstick (A).
9 Perform steps 4 and 3 in the reverse order
A
B
A
D
C
Engine System - LPG
109
P200132