Nilfisk-ALTO FLOORTEC R 870 Service Manual page 79

Service Manual – Floortec R 870
Dynamotor Carbon Brush Check/Replacement (Floortec R 870 Petrol)
Disassembly
1 Drive the machine on a level floor.
2 Turn the ignition key to "0" and engage the parking brake
3 Open the engine compartment hood with the handle and fasten it with the support rod Disconnect the
batteries
4 Remove the machine right side bulkhead, by lifting it to disengage it from the fasteners.
5 Remove the two screws (A) and remove the case (B)
6 If necessary, clean the external side of the dynamotor (C) in the area of the protection band (D).
7 Disengage the cam lever (E) and remove the protection band (D) of the dynamotor (C)
D
A
B
C
Electrical System
79
P200122