Nilfisk-ALTO FLOORTEC R 870 Service Manual page 231

Service Manual – Floortec R 870
Driver's Seat Microswitch Disassembly/Assembly
Disassembly
1 Drive the machine on a level floor.
2 Turn the ignition key to "0" and engage the parking brake
3 Open the battery/engine compartment hood
Disconnect the battery connector (Floortec R 870 Battery) - Disconnect the batteries (Floortec R 870
Petrol/LPG)
4 On the lower side of the battery/engine compartment (A), remove the driver's seat microswitch connector
(B) from its housing and disconnect it
5 Close the hood (A)
6 Move the seat (C) forward and remove it from the rails (D)
7 Retrieve the seat (C) with the wiring harness (E)
8 If necessary, remove the screws (F) and remove the seat rails (D).
Assembly
9 Assemble the components in the reverse order of disassembly, and note the following:
• Before tightening the screws (F) check that the seat rails (D) are aligned
• After the seat have been reinstalled, check that it slides properly on the rails, and also check that it
engages properly in each position
A
B
Wheel System, Traction
C
F
D
F
D
231
F
E
F
P200212