Nilfisk-ALTO FLOORTEC R 870 Service Manual page 145

Service Manual – Floortec R 870
Hydraulic Control Unit Disassembly/Assembly
Disassembly
1 Drive the machine on a level floor.
2 Ensure that the hopper is closed
3 Turn the ignition key to "0" and engage the parking brake
4 Open the battery/engine compartment hood with the handle and fasten it with the support rod
Disconnect the battery connector (Floortec R 870 Battery) - Disconnect the batteries (Floortec R 870
Petrol/LPG)
5 Remove the machine right side bulkhead (A), by lifting it to disengage it from the fasteners.
6 Disconnect the vacuum system motor connector (B)
7 Disengage the retainers (C) and remove the vacuum system hood (D)
A
C
B
Hopper System
C
D
C
145
C
P200233