Nilfisk-ALTO FLOORTEC R 870 Service Manual page 141

Service Manual – Floortec R 870
Hopper Disassembly/Assembly
Disassembly
1 Empty the hopper
2 Drive the machine on a level floor.
3 Engage the parking brake
4 Operating on the machine controls, as shown in the User Manual, lift the hopper (A), then lower it by
laying it on a wide holder (B), as shown in the figure (to safely support it during the disassembly).
5 Turn the ignition key to "0"
6 On the left side of the hopper (A), remove the screw (C) and retrieve the components (D).
7 Turn the lever (E) to rest position
8 The side flange (F) for hopper adjustment must be left in its original position. If necessary, it will be
adjusted after the hopper reassembly
9 Remove the two screws (G) on both sides of the hopper (A) and retrieve the components (H)
10 Remove the hopper (A) by disengaging the lifting arms (I) with the lever
G
G
E
C
H
H
E
F
C
I
A
B
H
Hopper System
D
I
G
G
H
P200156
141