Removal And Installation - Nilfisk-ALTO FLOORTEC R 870 Service Manual

Service Manual – Floortec R 870

Removal and Installation

Battery Charger Disassembly/Assembly (Floortec R 870 Battery)
Disassembly
1 Drive the machine on a level floor.
2 Turn the ignition key to "0" and engage the parking brake
3 Open the battery compartment hood with the handle and fasten it with the support rod Disconnect the
battery connector
4 Remove the screws (A) and the battery charger connector (B)
5 Remove the screws (C) on the rear side of the bulkhead, then remove the battery charger protection (D).
6 Remove the screws with the nut (E) and remove the battery charger (F) with the wiring harness (G)
Assembly
7 Assemble the components in the reverse order of disassembly, and note the following:
• The selector (H) must be turned to WET or GEL, according to the type of batteries (WET or GEL)
installed on the machine
B
A
E
D
H
E
Electrical System
C
C
E
F
E
78
P200125