Removal And Installation - Nilfisk-ALTO FLOORTEC R 870 Service Manual

Service Manual – Floortec R 870

Removal and Installation

Dashboard Electronic Board Disassembly/Assembly
Disassembly
1 Drive the machine on a level floor.
2 Turn the ignition key to "0" and engage the
parking brake
3 Open the battery/engine compartment hood
Disconnect the battery connector (Floortec R 870
Battery) - Disconnect the batteries (Floortec R
870 Petrol/LPG)
4 Remove the fastening screws (A) of the fairing
(B) from the steering column
5 Slightly lift the steering column (B) by
disengaging it from the lower fastener (C)
6 Disconnect the dust guard system quick coupling
(D)
A
A
A
A
B
G
E
7 Retrieve the fairing (B)
8 Under the left side of the control panel,
disconnect the connectors (E) of the dashboard
electronic board (F)
9 Disengage the four nuts (G) and remove the
dashboard electronic board (F)
Assembly
10 Assemble the components in the reverse order of
disassembly, and note the following:
• Set the type of batteries installed on the ma-
chine (see Electrical System chapter)
C
F
G
Control System
42
B
D
P200101