Scheduled Maintenance Table; Battery Charger Cable Check; Battery Charging - Nilfisk-ALTO FLOORTEC 760 User Manual

ENGLISH

SCHEDULED MAINTENANCE TABLE

Procedure

Battery charging

Battery (WET) fluid level check

Battery charger cable check

Dust filter cleaning and integrity check
Side and main broom height check and adjustment
Skirt height and operation check
Filter gasket check
Electrical filter shaker operation check (optional)
Driving belt check/adjustment: drive system, main broom.
Hopper position microswitch operation check
Driving belt replacement: drive system, main broom.
Motor carbon brush check or replacement
(*) For the relevant procedure, refer to the Service Manual.
(1) Daily or after using the machine.
(2) Or before use.
BATTERY CHARGER CABLE CHECK
Carefully check the battery charger cable (38) and the relevant plug for wear, cuts, cracks or other damages.
If the battery charger cable or the relevant plug is damaged, contact the Nilfisk-Alto Service Center.
BATTERY CHARGING
CAUTION!
Charge the batteries when the yellow (5) or red LED (6) turns on, or at the end of each cleaning cycle. Keeping
the batteries charged make their life last longer.
WARNING!
When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter.
WARNING!
If the machine is equipped with lead (WET) batteries, battery charging produces highly explosive hydrogen gas.
Charge the batteries in well-ventilated areas and away from naked flames.
Do not smoke while charging the batteries.
While charging the batteries always keep the hood open.
WARNING!
Pay careful attention when charging WET batteries as there may be battery fluid leakages. The battery fluid is
corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.
1. Drive the machine on a level floor. Make sure that the machine cannot move independently.
2. Turn the ignition key (2) to "0".
3. Connect the cable (38) of the electronic battery charger (40) to the electrical mains.
WARNING!
The mains voltage and frequency must match the electronic battery charger values shown on the machine serial
number plate (47).
14
USER MANUAL
FLOORTEC 760 - 1465380000
Upon delivery Every 10
hours
(1)
(2)
Every 50 Every 200
hours hours
(*)
(*)
(*)
Every 400
hours
(*)