Removal And Installation - Nilfisk-ALTO FLOORTEC R 870 Service Manual

Service Manual – Floortec R 870

Removal and Installation

Driving Belt Visual Inspection and Replacement
Check
1 Drive the machine on a level floor.
2 Turn the ignition key to "0" and engage the parking brake
3 Remove the machine right door by turning the relevant fasteners
4 Visually inspect the entire length of the belt (A) to make sure it is intact and shows no signs of cuts,
tears or cracks, if necessary replace it.
Replacement
5 Loosen the screws (C) and (D), then loosen the belt by turning the motor assembly (B).
6 Remove the belt (A)
7 Install the new belt (A)
8 Tighten the belt (A) as necessary by turning the motor assembly (B), then tighten the screws (C) and
(D)
Reassembly
9 Install the machine right door by turning the relevant fasteners
B
C
C
D
A
Main Broom System
169
P200173