Nilfisk-ALTO FLOORTEC R 870 Service Manual page 8

Service Manual – Floortec R 870
– Sharp turns must be made at slowest possible speed. Avoid: abrupt turns on incline, turns when
the hopper is lifted
– Do not lift the hopper when the machine is on incline The machine loses stability on incline or
when the hopper is full
– Keep the batteries away from sparks, flames and incandescent material. During the normal op-
eration explosive gases are released
– Do not wear jewels when working near electrical components
– Do not work under the lifted machine without supporting it with safety stands
– When working under the open hood, ensure that it cannot be closed by accident.
– Do not operate the machine near toxic, dangerous, flammable and/or explosive powders, liquids
or vapors: This machine is not suitable for collecting dangerous powders.
– (For WET batteries only). Keep the battery away from sparks, flames and incandescent material.
During the normal operation explosive gases are released
(For Floortec R 870 Petrol/LPG)
– Carbon monoxide (CO) can cause brain damage or death
– The internal combustion engine of this machine can emit carbon monoxide
– Do not inhale exhaust gas fumes
– Only use indoors when adequate ventilation is provided, and with the help of an assistant.
(For Floortec R 870 Petrol/LPG)
– Be careful: fuel is highly flammable.
– Do not smoke or bring naked flames in the area where the machine is refuelled or where the fuel
is stored
– Refuel outdoors or in a well-ventilated area, with the engine off.
– Turn off the engine and let it cool down for a few minutes, then remove the fuel tank plug.
– Leave at least a space of 4 cm in the filler to allow the fuel to expand.
– After refuelling, check that the fuel tank cap is firmly closed.
– If any fuel is spilled while refuelling, clean the tank area and allow the vapors to evaporate be-
fore starting the engine
– Do not let fuel come into contact with the skin; do not breathe fuel vapors Keep out of reach of
children
– Do not tilt the engine too much to avoid fuel spillage
– When moving the machine, the fuel tank must not be full and the fuel valve must be closed.
– Do not lay any object on the engine
– Stop the engine before performing any procedure on it. To avoid any incidental start, disconnect
the spark plug cap or disconnect the battery negative terminal
– See also the SAFETY RULES in the Engine Manual, which is to be considered an integral part of
this Manual
– (For LPG version) Do not use the machine in case of gas leaks Disconnect the fuel hose and
replace the LPG tank. If the gas leak persists, disconnect the fuel hose and contact the Nilfisk-
Advance Service Center
General Information
8