Nilfisk-ALTO FLOORTEC R 870 Service Manual page 81

Service Manual – Floortec R 870
Dynamotor Disassembly/Assembly (Floortec R 870 Petrol)
Disassembly
1 Remove the engine-dynamotor (see the procedure at the relevant paragraphs in Engine System, Petrol
or Engine System, LPG).
2 Remove the dynamotor carbon brushes (refer to the procedure "Dynamotor Carbon Brushes Check/
Replacement")
3 Hold the crankshaft by operating the outer pulley in the area (B), loosen the lock nut (A) until it is flush
with the end of the shaft
4 Remove the two screws (C) with nuts (D) fastening the dynamotor (M) to the holder (E) Retrieve the
washers
5 Remove the four screws (F) with nuts (G) fastening the dynamotor to the engine Retrieve the washers
6 Remove the screw in the area (N), then remove the baffle plate (H).
F
F
A
E
H
N
M
D
C
G
G
Electrical System
81
B
P200228