Nilfisk-ALTO FLOORTEC R 870 Service Manual page 165

Service Manual – Floortec R 870
Main Broom Disassembly/Assembly (Continues)
Assembly
8 Check that the drive hub (F) is free from dirt or foreign materials (cords, rags, etc.) accidentally rolled
up
9 The main broom (E) must be installed with the bristles rows (G) bent as shown in the figure.
During assembly, ensure that the broom hexagonal mesh (H) fits into the relevant drive hub (F).
10 Install the broom compartment latch(C). Ensure that its fasteners (I) are properly fitted in the housings
(J) of the machine chassis
11 Turn the levers (B) to lock the latch (C) in its housing
12 Screw down the knob (A)
13 Install the left door and secure it with the relevant fasteners
14 Check and, if necessary, adjust the main broom height.
B
A
J
I
B
C
J
C C
F
I
Main Broom System
G
E
H
165
P200171