Nilfisk-ALTO FLOORTEC R 870 Service Manual page 222

Service Manual – Floortec R 870
Front Wheel Rubber Ring Disassembly/Assembly (Continues)
6 Remove the screws (G) on the left side of the front wheel assembly
7 Remove the spacer (H)
8 Remove the left bracket (I); if necessary use a puller (J)
9 Unscrew the nuts (K) and remove the fastening screws (L) of the rubber ring (N) Retrieve the washers
(M)
10 Remove the rubber ring (N) from the reduction unit (P)
Assembly
11 Assemble the components in the reverse order of disassembly, and note the following:
• To ease the installation of the rubber ring (N) on the reduction unit (P), slightly hit the side edge of
the rubber ring with a plastic mallet in a criss-cross pattern
• Tighten the rubber ring fastening nuts (K) at 16 Nm
• Tighten the left bracket fastening screws (G) at 22 Nm
12 Adjust the brake as described in the procedure for brake cable disassembly/assembly
K
M
K
M
G
P
J
H
N
M
M
L
Wheel System, Traction
I
I
L
P200204
222