Nilfisk-ALTO FLOORTEC R 870 Service Manual page 72

Service Manual – Floortec R 870
Battery Removal/Installation and Battery Type Setting (WET or GEL/AGM)
(Floortec R 870 Battery) (Continues)
Battery Setting (WET or GEL-AGM)
9 Remove the support rod and close the battery compartment hood with the handle
10 Turn the ignition key to "I" by pressing the push-button (G) and by holding it (for about 5") until the
warning light corresponding to the current setting flashes:
• Red warning light (H): WET batteries
• Green warning light (I): GEL-AGM batteries
11 Release and press again the push-button (G) within 5 seconds to change setting
12 Wait until the warning light corresponding to the new setting stops flashing (5 seconds approx.).
13 The new setting is properly stored
14 Set the type of batteries (WET or GEL-AGM) on the battery charger (K) (if equipped) too by activating
the relevant selector (L)
H
G
I
L
Electrical System
72
K
P200124