Nilfisk-ALTO FLOORTEC R 870 Service Manual page 215

Service Manual – Floortec R 870
Brake Cable Disassembly/Assembly
Disassembly
1 If possible, place the machine on a hoisting system.
2 Turn the ignition key to "0" Ensure that the machine cannot move by placing opposite wedges (A) on the
rear wheels
3 Remove the left side broom, if equipped.
4 Steer the front wheel to the right, about 90°.
5 Unscrew nut and locknut (B) then remove the brake cable (C) from the brackets (D)
6 Under the brake pedal, loosen the nut-locknut (H) of the brake cable (C).
7 Remove the clip with the pin (F)
8 Disconnect from the brake pedal the terminal (G) of the cable (C) of the brake
9 Remove the cable (C) through the slot (L)
D
C
B
E
L
H
C
Wheel System, Traction
I
G
F
215
A
C
P200200