Service Manual – Floortec R 870
Accelerator Pedal Disassembly/Assembly
Disassembly
1
If possible, place the machine on a hoisting system.
2
Loosen the screw (B) under the accelerator pedal (A)
3
Remove the accelerator pedal (A) from the shaft (C)
4
Remove the three fastening screws (D) of the accelerator pedal control (E)
5
Disconnect the accelerator pedal control connector (F)
6
Disengage the electrical cable (G) from the retaining clamps (H)
7
Retrieve the accelerator pedal control (E) with the wiring harness
Assembly
8
Assemble the components in the reverse order of disassembly, and note the following:
• Fasten the accelerator pedal (A) on the shaft (C) with the screw (B) under the following condition:
• with the accelerator pedal at the front end of stroke, the surface (I) must be aligned with the surface
(J)
A
I
D
J
C
E
B
Wheel System, Traction
E
G
229
F
H
P200210