Output Shaft Thrust Plate; Assembling Front And Rear Clutch Units; Output Shaft Thrust Washer; Aligning Rear Clutch Disc Lugs - Jeep 200 Cherokee Service Manual

21 - 172 AUTOMATIC TRANSMISSION—30RH
DISASSEMBLY AND ASSEMBLY (Continued)
(29) Install output shaft thrust plate on shaft hub
in planetary geartrain driving shell (Fig. 152). Use
petroleum jelly to hold thrust plate in place.
(30) Check rear clutch thrust washer. Use addi-
tional petroleum jelly to hold washer in place if nec-
essary.
(31) Coat output shaft thrust washer with petro-
leum jelly. Install washer in rear clutch hub (Fig.
154). Use enough petroleum jelly to hold washer in
place. Be sure grooved side of washer faces
rearward (toward output shaft) as shown. Also
note that washer only fits one way in clutch
hub.
Fig. 152 Output Shaft Thrust Plate
1 – OUTPUT SHAFT HUB
2 – OUTPUT SHAFT THRUST PLATE
Fig. 153 Assembling Front And Rear Clutch Units
1 – TURN FRONT CLUTCH BACK & FORTH UNTIL SEATED
2 – REAR CLUTCH ASSEMBLY
(32) Align drive teeth on rear clutch discs with
small screwdriver (Fig. 155). This will make installa-
tion into front of planetary geartrain easier.
Fig. 154 Output Shaft Thrust Washer
1 – REAR CLUTCH HUB
2 – OUTPUT SHAFT THRUST WASHER
3 – OUTPUT SHAFT
Fig. 155 Aligning Rear Clutch Disc Lugs
1 – REAR CLUTCH DISCS
2 – USE SMALL SCREWDRIVER TO ALIGN CLUTCH DISC
TEETH
(33) Insert front band into opening at front of
transmission case (Fig. 156).
(34) Install front and rear clutch units as assembly
(Fig. 157). Align rear clutch with front annulus gear
and install assembly in driving shell. Be sure out-
put shaft thrust washer and thrust plate are
not displaced during installation.
(35) Carefully work assembled clutches back and
forth to engage and seat rear clutch discs on front
annulus gear. Verify that front clutch drive lugs are
XJ