Rear Slinger Removal; Rear Retainer Seal; Output Shaft Rear Bearing Retaining Ring; Rear Retainer Removal - Jeep 200 Cherokee Service Manual

21 - 352 NV231 TRANSFER CASE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 9 Rear Slinger Removal
1 – TRANSFER CASE
2 – SPECIAL TOOL MD998056–A
3 – SLINGER
Fig. 10 Rear Retainer Seal
1 – REAR RETAINER
2 – OUTPUT SHAFT SEAL
(9) Remove rear retainer from rear case half (Fig.
12).
(10) Remove snap-ring holding oil pump in posi-
tion on output shaft.
(11) Disengage oil pickup tube from oil pump and
remove oil pump assembly. Remove oil pump by tilt-
ing the edge of the oil pump from under the edge of
the rear case half and sliding the pump (Fig. 13).
(12) Remove pick-up tube o-ring from oil pump
(Fig. 14), if necessary. Do not disassemble the oil
pump, it is not serviceable.
Fig. 11 Output Shaft Rear Bearing Retaining Ring
1 – REAR RETAINER
2 – OUTPUT SHAFT SEAL
Fig. 12 Rear Retainer Removal
1 – MAINSHAFT
2 – REAR RETAINER
Fig. 13 Oil Pump Removal
1 – OIL PUMP
XJ