Front Band Reaction Pin; Front Band Lever; Rear Band Servo Lever Pin; Compressing Front Servo - Jeep 200 Cherokee Service Manual

XJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 141 Front Band Reaction Pin
1 – PENCIL MAGNET
2 – FRONT BAND REACTION PIN
Fig. 142 Front Band Lever
1 – FRONT BAND LEVER
Fig. 143 Rear Band Servo Lever Pin
1 – PARALLEL JAW SNAP RING PLIERS
2 – REAR BAND LEVER PIVOT PIN
AUTOMATIC TRANSMISSION—30RH
(34) Compress front servo rod guide about 1/8 in.
with large C-clamp and Tool C-4470, or Spring Com-
pressor Tool C-3422-B (Fig. 144).
(35) Remove front servo rod guide snap ring (Fig.
144). Exercise caution when removing snap
ring. Servo bore can be scratched or nicked if
care is not exercised.
(36) Remove compressor tools and remove front
servo rod guide, spring and servo piston.
(37) Compress rear servo spring retainer about
1/16 in. with C-clamp and Tool C-4470 or SP-5560
(Fig. 145). Valve Spring Compressor C-3422-B can
also be used to compress spring retainer.
(38) Remove rear servo spring retainer snap ring.
Then remove compressor tools and remove rear servo
spring and piston.
Fig. 144 Compressing Front Servo
1 – SPRING COMPRESSOR TOOL C-3422–B
2 – ROD GUIDE SNAP RING
ASSEMBLY
(1) Install rear servo piston, spring and spring
retainer. Compress rear servo spring and retainer
with Compressor Tool C-3422-B (Fig. 145) or a large
C-clamp.
(2) Install front servo piston, spring, and rod
guide. Compress front servo rod guide with Valve
Spring Compressor C-3422-B and install servo snap
ring (Fig. 144).
(3) Assemble link bar to band. Notched side of link
toward band (Fig. 143).
(4) Insert rear band through pan opening in trans-
mission case.
(5) Insert hook on band onto adjuster lever.
(6) Align holes in link bar with hole in transmis-
sion case outboard of rear support opening (Fig. 142).
(7) Insert anchor pin into case through link bar.
21 - 169