XJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 94 Adjusting Screw Bracket, Springs, Valve
1 – ADJUSTER BRACKET
2 – LINE PRESSURE ADJUSTER
3 – PRESSURE REGULATOR VALVE
4 – SWITCH VALVE
5 – VALVE BODY
6 – TRANSFER PLATE
7 – THROTTLE VALVE
8 – SLEEVE
9 – KICKDOWN VALVE
10 – THROTTLE PRESSURE ADJUSTER
Fig. 95 Securing Detent Ball And Spring With
Retainer Tool
1 – SPECIAL TOOL 6583
2 – DETENT BALL AND SPRING HOUSING
(11) Remove converter clutch solenoid from separa-
tor plate (Fig. 99). A T25 torx bit is required to
remove solenoid attaching screw.
(12) Remove screws attaching converter clutch
module to valve body and remove module and con-
necting tube (Fig. 100).
(13) Remove screws attaching end cover plate to
torque converter module (Fig. 101).
(14) Remove converter clutch valve, fail safe valve,
and springs (Fig. 101)
Removal
AUTOMATIC TRANSMISSION—30RH
Fig. 96 Manual And Throttle Levers
1 – PARK ROD
2 – E-RING
3 – WASHER
4 – MANUAL LEVER
5 – MANUAL VALVE
6 – SPRING
7 – DETENT BALL
8 – VALVE BODY
Fig. 97 Manual Valve
1 – MANUAL VALVE
2 – VALVE BODY
(15) Turn valve body over so transfer plate is fac-
ing upward (Fig. 102). With valve body in this posi-
tion, valve body check balls will remain in place and
not fall out when transfer plate is removed.
(16) Remove screws attaching transfer plate to
valve body (Fig. 102).
(17) Remove transfer plate and separator plate
from valve body (Fig. 102). Note position of filter and
clutch solenoid for reference. Remove valve body
check balls.
21 - 157