Installing Assembled Sun Gear And Driving Shell On Output Shaft; Installing Rear Thrust Washer On Front Planetary Gear; Installing Front Planetary And Annulus Gears; Positioning Thrust Plate On Front Annulus Support - Jeep 200 Cherokee Service Manual

XJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 210 Installing Assembled Sun Gear And Driving
Shell On Output Shaft
1 – SUN GEAR/DRIVING SHELL ASSEMBLY
2 – OUTPUT SHAFT
Fig. 211 Installing Rear Thrust Washer On Front
Planetary Gear
1 – FRONT PLANETARY GEAR
2 – REAR TABBED THRUST WASHER
(14) Install front planetary gear on output shaft
and in driving shell (Fig. 212).
(15) Install front thrust washer on front planetary
gear. Use enough petroleum jelly to hold washer in
place and be sure all four washer tabs are seated.
(16) Assemble front annulus gear and support, if
necessary. Be sure support snap ring is seated.
(17) Install front annulus on front planetary (Fig.
212).
(18) Position thrust plate on front annulus gear
support (Fig. 213). Note that plate has two tabs
on it. These tabs fit in notches of annulus hub.
AUTOMATIC TRANSMISSION—30RH
Fig. 212 Installing Front Planetary And Annulus
1 – FRONT PLANETARY GEAR
2 – FRONT THRUST WASHER
3 – FRONT ANNULUS GEAR
Fig. 213 Positioning Thrust Plate On Front Annulus
1 – FRONT ANNULUS
2 – THRUST PLATE
(19) Install thrust washer in front annulus (Fig.
214). Align flat on washer with flat on planetary
hub. Also be sure washer tab is facing up.
(20) Install front annulus snap ring (Fig. 215). Use
snap ring pliers to avoid distorting ring during
installation. Also be sure ring is fully seated.
(21) Install planetary selective snap ring with
snap ring pliers (Fig. 216). Be sure ring is fully
seated.
(22) Turn planetary geartrain assembly over so
driving shell is facing workbench. Then support
geartrain on wood block positioned under forward
end of output shaft. This allows geartrain compo-
nents to move forward for accurate end play check.
(23) Check planetary geartrain end play with
feeler gauge (Fig. 217). Gauge goes between shoulder
on output shaft and end of rear annulus support.
Gears
Support
21 - 189