Removing Clutch Drum Bearing And Race; Removing Clutch Pack Snap Ring; Removing Clutch Piston Snap Ring; Removing Overdrive Clutch Piston - Jeep 200 Cherokee Service Manual

XJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 207 Removing Clutch Drum Bearing And Race
1 – CLUTCH DRUM
2 – THRUST BEARING AND RACE
Fig. 208 Removing Clutch Pack Snap Ring
1 – SNAP RING
2 – CLUTCH RETAINER
out (Fig. 210). Apply only enough air pressure to
remove piston.
(12) Measure free length of piston return springs
with springs in retainer (Fig. 211). Length should be
16.8 mm (0.661 in.). Replace spring and retainer
assembly if necessary.
(13) Check clutch piston check ball (Fig. 212).
Shake piston to see if ball moves freely. Then check
AW–4 AUTOMATIC TRANSMISSION
Fig. 209 Removing Clutch Piston Snap Ring
1 – COMPRESSOR TOOL
2 – CLUTCH PISTON SNAP RING
Fig. 210 Removing Overdrive Clutch Piston
1 – CLUTCH RETAINER
2 – CLUTCH PISTON
3 – OIL PUMP
4 – CONVERTER
ball sealing by applying low pressure compressed air
to ball inlet as shown. Air should not leak past check
ball.
21 - 303