Installation - Left Side; Engine Mounts - Rhd Diesel; Left Engine Mount Retaining Bolts - Jeep 200 Cherokee Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
(13) Position a jack stand and raise the weight off
the left engine mount.
(14) Remove the (4) engine mount bracket bolts
from the engine block.
(15) Remove the (4) trackbar support bracket bolts
and remove the bracket (Fig. 9).
Fig. 9 Left Engine Mount Retaining Bolts
1 – TRACK BAR SUPPORT BRACKET RETAINING BOLTS
2 – ENGINE MOUNT SILL PLATE BOLT
(16) Remove the remaining engine mount lower
sill plate bolt (Fig. 9).
(17) Remove the engine mount troughbolt.
(18) Remove the left engine mount from the vehi-
cle.
INSTALLATION—LEFT SIDE
(1) Position the engine mount and bracket and
install the engine mount through bolt and nut, leav-
ing them loose at this time.
(2) Install, but do not torque the engine mount
lower sill plate bolt and the trackbar support bracket
bolts (Fig. 9).
(3) Install the (4) engine mount bracket bolts.
Torque to 61 N·m (45 ft. lbs.).
(4) Torque the lower engine mount sill plate bolts
to 41 N·m (30 ft. lbs.) (Fig. 9).
(5) Torque the larger trackbar support bracket
bolts to 125 N·m (92 ft. lbs.) (Fig. 9).
(6) Remove the jack stand.
(7) Position the H-Block and the A/C Compressor
in there original positions and install the retaining
bolts (Fig. 10).
(8) Torque the A/C Compressor mounting bolts to
41 N·m (30 ft. lbs.) (Fig. 10).
2000 JEEP CHEROKEE
Fig. 10 A/C Compressor Position & Orientation
1 – A/C COMPRESSOR MOUNTING BOLTS
2 – LEFT ENGINE MOUNT THROUGHBOLT NUT
3 – H BLOCK BOLTS
4 – COUPLER PINCH BOLT
5 – COMPRESSOR ELECTRICAL CONNECTOR
(9) Torque all the H-Block retaining bolts to 18
N·m (159 in. lbs.).
(10) Torque the engine mount throughbolt nut to
65 N·m (48 ft. lbs.) (Fig. 10).
(11) Install the steering shaft. Torque the pinch-
bolt to 49 N·m (36 ft. lbs.).
(12) Lower the vehicle from the hoist.
(13) Install the engine mount upper sill plate nuts.
Torque to 41 N·m (30 ft. lbs.) (Fig. 11).
(14) Install the refrigerant line support bracket on
the rear of the rocker cover.
(15) Connect the A/C compressor electrical connec-
tor.
(16) Connect the negative battery cable.
ENGINE MOUNTS — RHD DIESEL
The engine mounts support the engine at each
side. These supports are made of resilient rubber.
REMOVAL—RIGHT SIDE
(1) Disconnect the negative battery cable.
(2) Make sure the steering wheel is in the
unlocked position. Raise the vehicle on a hoist.
(3) Remove the steering shaft pinchbolt and slide
the steering shaft straight off the gearbox input
shaft.
ENGINE 9 - 15