Rear Door Stationary Window Glass Installation; Rear Quarter Window Glass Removal And Installation; Division Bar/Stationary Glass; Quarter Window Reveal Molding, Glass And Seal - Jeep 200 Cherokee Service Manual

23 - 10 BODY
REMOVAL AND INSTALLATION (Continued)
(3) Remove the trim panel and waterdam from
door inner panel.
(4) Remove the screws attaching the division bar/
glass to the door (Fig. 7).
(5) Tilt the division bar/glass forward and remove
it from the door.
Fig. 7 Division Bar/Stationary Glass
1 – UPPER SCREW
2 – GLASS
3 – LOWER SCREW
4 – DIVISION BAR
INSTALLATION
(1) Position the division bar/glass in the door.
(2) Install the screws attaching the division bar/
glass to the door. Finger tighten the screws.
(3) Tighten the upper screw to 6 N·m (5 ft-lbs)
torque.
(4) Tighten the lower screw to 6 N·m (5 ft-lbs)
torque.
(5) Install the beltline weatherstrip.
(6) Install the door waterdam and trim panel.
REAR QUARTER WINDOW GLASS
REMOVAL
(1) If equipped, remove the quarter window reveal
molding (Fig. 8).
(2) Remove the quarter window interior trim cov-
ers.
(3) Separate the weatherstrip seal lip from the
window opening flanges. Use a pry tool and carefully
push the window glass and seal outward.
(4) Remove the weatherstrip seal and window
glass from window opening.
(5) Remove the weatherstrip seal from the window
glass.
Fig. 8 Quarter Window Reveal Molding, Glass and
1 – GLASS
2 – REVEAL MOULDING
3 – WEATHERSTRIP SEAL
INSTALLATION
(1) Clean the original sealant from the weather-
strip channels and window opening flanges.
(2) Apply a 4-mm (1/6-in) diameter bead of sealant
to the window channel in the weatherstrip seal.
(3) Install the weatherstrip on the window glass.
Install the seal installation cord in the window open-
ing flange channel (Fig. 9) as follows:
• Moisten a length of 6-mm (1/4-in) diameter cord
with a soap and water solution.
• Ensure that the cord is long enough to go all the
way around the perimeter of the weatherstrip.
• Insert the cord into the window opening flange
channel in the weatherstrip seal.
(4) Apply a 6-mm (1/4-in) diameter bead of sealant
to the window opening flanges.
(5) For two-door vehicles, apply a 3-mm (1/8-in)
diameter bead of sealant at the quarter panel appli-
que and liftgate pillar seam.
(6) Position the quarter window glass and the
weatherstrip seal in the window opening (Fig. 10)
with the free ends of the cord inside the vehicle (Fig.
11).
(7) Pull on each end of the cord to pull the weath-
erstrip seal channel lip over the window opening
flanges.
(8) Test the vent window for water leaks.
(9) Install the interior trim cover.
(10) If equipped, install the quarter window reveal
molding.
Seal
XJ