Right Engine Mount Sill Plate Nuts - Jeep 200 Cherokee Service Manual

9 - 16 ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 11 Left Engine Mount Sill Plate Nuts
1 – SILL PLATE NUTS
2 – STEERING SHAFT
3 – ENGINE MOUNT
CAUTION: Do not rotate the steering shaft while
removed from the gearbox input shaft. Damage to
the steering column clockspring will occur.
(4) Remove the oil filter adaptor retaining bolt and
remove oil filter and adaptor from the vehicle.
(5) Remove the engine mount upper sill plate nuts
(Fig. 12).
Fig. 12 Right Engine Mount Sill Plate Nuts
1 – SILL PLATE NUTS
2 – STEERING SHAFT
3 – ENGINE MOUNT
2000 JEEP CHEROKEE
(6) Remove the engine mount throughbolt nut only.
Leave the bolt installed at this time.
(7) Position a jack stand and raise the weight off
the right engine mount.
(8) Remove the (4) trackbar support bracket
retaining bolts and remove the bracket.
(9) Remove the (4) engine mount bracket bolts
from the engine block.
(10) Remove the remaining engine mount lower
sill plate bolt.
(11) Remove the engine mount through bolt.
(12) Remove the right engine mount from the vehi-
cle.
INSTALLATION—RIGHT SIDE
(1) Position the engine mount and bracket in posi-
tion and install the engine mount through bolt and
nut, leaving them loose at this time.
(2) Install, but do not torque the engine mount
lower sill plate bolts and the trackbar support
bracket bolts.
(3) Install the (4) engine mount bracket to engine
block retaining bolts. Torque bolts to 61 N·m (45 ft.
lbs.).
(4) Torque the engine mount lower sill plate bolts
to 41 N·m (30 ft. lbs.).
(5) Torque the larger trackbar support bracket
bolts to 125 N·m (92 ft. lbs.).
(6) Install the oil filter and adaptor on the engine.
Torque oil filter adaptor retaining bolt to 69 N·m (51
ft. lbs.).
(7) Remove the jack stand.
(8) Install the engine mount upper sill plate nuts.
Torque to 41 N·m (30 ft. lbs.).
(9) Torque the engine mount throughbolt nut to 65
N·m (48 ft. lbs.).
(10) Install the steering shaft and torque the
pinchbolt to 49 N·m (36 ft. lbs.).
(11) Lower the vehicle from the hoist.
(12) Connect the negative battery cable.
REMOVAL—LEFT SIDE
(1) Disconnect the negative battery cable.
(2) Remove the refrigerant line support bracket
bolt from the upper radiator support crossmember..
(3) Remove the A/C filter-drier assembly support
bracket nuts from the left fenderwell.
(4) Disconnect A/C compressor electrical connector
(Fig. 13).
(5) Raise the vehicle on a hoist.
(6) Remove the engine mount throughbolt nut only
(Fig. 13). Leave the bolt installed at this time.
(7) Loosen the (4) H-Block retaining bolts, Do not
remove the bolts at this time.
XJ