Side View Mirror Removal And Installation; Front Fender Flare Removal And Installation; Exterior Nameplates - Jeep 200 Cherokee Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
Fig. 15 Exterior Nameplates
1 – CHEROKEE
2 – LIMITED-SPORT-CLASSIC
SIDE VIEW MIRROR
REMOVAL
(1) Remove the door trim panel.
(2) Remove the screw attaching the mirror trim
cover/speaker grille to the door inner panel.
(3) remove push-in fastener attaching trim cover
to door inner panel (use special tool C-4829).
(4) Disconnect the power mirror wire connector, if
equipped.
(5) Remove the screws attaching the mirror to the
door (Fig. 16).
(6) Separate the mirror from the door.
Fig. 16 Side View Mirror
1 – SIDE VIEW MIRROR
2 – WIRE HARNESS
3 – SEAL
4 – GROMMET
5 – DOOR
INSTALLATION
(1) Position the mirror on the door.
(2) Install the screws attaching the mirror to the
door.
(3) Connect the power mirror wire connector, if
equipped.
(4) Install new push-in fastener.
(5) Install the mirror trim cover/speaker grille.
(6) Install the door trim panel.
FRONT FENDER FLARE
REMOVAL
(1) Remove the screw attaching the lower part of
flare to the bottom of the fender.
(2) Remove the nuts attaching the fender flare
retainer to the wheelhouse splash shield (Fig. 17).
(3) Remove the liner from the fender.
(4) Remove the fasteners attaching the fender flare
and retainer to the fender.
(5) Separate the fender flare and retainer from the
fender.
Fig. 17 Fender Flare
1 – FENDER FLARE
2 – RETAINER
3 – FENDER
4 – LINER
5 – PUSH NUT
6 – RETAINER
INSTALLATION
(1) Position the fender flare and retainer on the
fender.
(2) Install the nuts attaching the fender flare and
retainer to the wheelhouse fender.
(3) Install the screw attaching the lower part of
flare to the bottom of the fender.
BODY 23 - 31