Installing Forward–Direct Clutch Thrust Bearing And Race; Installing Planetary Ring Gear Race; Aligning Forward–Direct Clutch Splines; Installing Front Planetary Ring Gear - Jeep 200 Cherokee Service Manual

XJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 158 Installing Forward–Direct Clutch Thrust
Bearing And Race
1 – THRUST BEARING
2 – RACE
3 – FORWARD-DIRECT CLUTCH ASSEMBLY
(42) Verify ring gear race size. Outer diameter is
47.0 mm (1.850 in.) and inside diameter is 26.5 mm
(1.045 in.).
Fig. 159 Installing Planetary Ring Gear Race
1 – PLANETARY RING GEAR
2 – THRUST RACE
(43) Align forward–direct clutch disc splines with
screwdriver (Fig. 160).
(44) Align and install front planetary ring gear in
forward–direct clutch (Fig. 161).
(45) Coat bearing and race with petroleum jelly
and install them in ring gear (Fig. 162). Verify bear-
ing/race size.
• Bearing outer diameter is 47.7 mm (1.878 in.)
and inside diameter is 32.6 mm (1.283 in.).
• Race outer diameter is 53.6 mm (2.110 in.) and
inside diameter is 30.6 mm (1.205 in.).
(46) Install assembled planetary gear/forward–di-
rect clutch (Fig. 163).
AW–4 AUTOMATIC TRANSMISSION
Fig. 160 Aligning Forward–Direct Clutch Splines
1 – CLUTCH SPLINE ALIGNING TOOL
2 – FORWARD-DIRECT CLUTCH
Fig. 161 Installing Front Planetary Ring Gear
1 – RING GEAR
2 – FORWARD-DIRECT CLUTCH
(47) Check clearance between sun gear input drum
and direct clutch drum (Fig. 164). Clearance should
be 9.8 – 11.8 mm (0.386 – 0.465 in.). If clearance is
incorrect, planetary
assembly is not seated or is improperly assembled.
Remove, and correct if necessary.
21 - 287
gear/forward–direct clutch