Figure 3-61: Dtmf & Dialing; Table 3-31: Dtmf And Dialing Parameters - AudioCodes MediaPack MP-124 User Manual

Configure the DTMF and dialing parameters according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.
4.
Parameter
Max Digits in Phone Num
[MaxDigits]
Inter Digit Timeout for
Overlap Dialing [sec]
[TimeBetweenDigits]
Declare RFC 2833 in SDP
[RxDTMFOption]
SIP User's Manual
Figure 3-61: DTMF & Dialing Page

Table 3-31: DTMF and Dialing Parameters

Defines the maximum number of collected destination number digits
that can be received (i.e., dialed) from the Tel side. When the number
of collected digits reaches the maximum, the device uses these digits
for the called destination number.
The valid range is 1 to 49. The default value is 5.
Notes:
Digit Mapping Rules can be used instead.
Dialing ends when the maximum number of digits is dialed, the
Interdigit Timeout expires, the '#' key is dialed, or a digit map
pattern is matched.
Defines the time (in seconds) that the device waits between digits that
are dialed by the calling party for Tel-to-IP calls. When this inter-digit
timeout expires, the device uses the collected digits to dial the called
destination number.
The valid range is 1 to 10. The default value is 4.
Defines the supported Receive DTMF negotiation method.
[0] No = Don't declare RFC 2833 telephony-event parameter in
SDP.
[3] Yes = Declare RFC 2833 telephony-event parameter in SDP
(default).
The device is designed to always be receptive to RFC 2833 DTMF
126
Description
Document #: LTRT-65411
MediaPack Series