Table of Contents
Advertisement
Serial Commands
Address
Serial Cmd:
<K160,protocol,address,protocol port>
Default:
1
Options:
1 – 50
1 = Poll address 0x1C, select address 0x1D
2 = Poll address 0x1E, select address 0x1F
...
50 = Poll address 0x7E, select address 0x7F
Protocol Port
Serial Cmd:
<K160,protocol,address,protocol
Default:
0
Options:
0 – 1
0 = Main RS-232 on QX Hawk Connector A
1 = RS-422/485 on QX Hawk Connector B
External Data Routing
Mode
Serial Cmd:
<K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default:
0 = Disabled
Options:
0 = Disabled
1 = Transparent
2 = Half Duplex
3 = Full Duplex
4 = Customized
Destination Port
Serial Cmd:
<K161,mode,destination
end of read cycle,output at ETX,output at timeout>
Default:
0 = RS-232 on QX Hawk Connector A
Options:
0 = RS-232 on QX Hawk Connector A
1 = RS-232 on QX Hawk Connector B
2 = RS-422 on QX Hawk Connector B
4 = Ethernet TCP Port 1
5 = Ethernet TCP Port 2
6 = EtherNet/IP
A-28
port>
port,ambles to source,echo to source,output at
QX Hawk Industrial Imager User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the QX Hawk and is the answer not in the manual?
Questions and answers