Table of Contents
Advertisement
Parameters
Response Timeout
Only used when a response is required from the host. While in Multidrop, if the imager
does not receive an ACK or NAK from the host after sending polled data, it will act on a
fault. The imager can be set to wait indefinitely by setting Response Timeout to zero.
The time that the imager will wait before timing out if ACK, NAK, and ETX are enabled,
and a host response is expected.
5-27
QX Hawk Industrial Imager User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the QX Hawk and is the answer not in the manual?
Questions and answers