Serial Utility Commands - Microscan QX Hawk User Manual

Serial Utility Commands

Serial Utility Commands

Note: For a list of all K commands, see
Type
Bar Code Configuration
Calibration
Counters
Default/Reset/Save
Device Control
Firmware/Checksum
7-2
Serial Commands
Command
<BCCFG> Enter Bar Code Configuration
<@CAL> Calibrate
<@OPTIC> Initiate Lens Calibration
<N> No Read Counter
<O> No Read Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
<V> Good Read/Match Counter
<W> Good Read/Match Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
<A> Software Reset – Retain Current Parameters
<Ard> Software Reset – Recall Factory Defaults
<Arp> Software Reset – Recall Power-On Defaults
<Arc> Software Reset – Recall Customer Defaults
<Z> Software Reset – Save Current Settings for Power-On
Software Reset – Save Current Settings as Customer
<Zc>
Defaults
Software Reset – Recall Factory Defaults and Save
<Zrd>
for Power-On
Software Reset – Recall Customer Defaults and
<Zrc>
Save for Power-On
<L1> Programmable Output 1
<L2> Programmable Output 2
<L3> Programmable Output 3
<I> Disable Imager
<H> Enable Imager
<#> Display All Part Numbers
<#a> Display Application Code Part Number
<#b> Display Boot Code Part Number
<#d> Display DSP Code Part Number
<#k> Display Kernel Code Part Number
<#s> Display SafeMode Part Number
<#.> Display All Firmware Build Numbers
<#a.> Display Application Code Build Number
on page A-12.
Name
QX Hawk Industrial Imager User's Manual