Default/Reset/Save - Microscan QX Hawk User Manual

Default/Reset/Save

Understanding and controlling the imager's active, saved, and default settings is critical to
its successful operation.
Reset (Will not save for power-on)
Reset and Recall Microscan Default
Parameters
Reset and Recall Power-On Parameters
Reset and Recall Customer Default
Parameters
Save Current Settings for Power-On
Save Current Settings as Customer
Default Parameters for Power-On
Recall Microscan Default Settings
and Save for Power-On (Will not
default "sticky settings")
Recall Customer Default Settings
and Save for Power-On
a. When right-clicking in a tree control to select Default Current Menu Settings or Default All ESP
Settings, it is important to note that only ESP settings are defaulted. To save these defaults to the
imager itself, follow up with a Save to Reader, Send and Save command.
b. Only available in ESP if enabled in Preferences (General tab), accessible from the Options dropdown menu.
Resets
Resets ("A" commands) affect only the current settings (active memory) and are not saved
for power-on.
Saved for Power-on
Power-on parameters ("Z" commands) are saved to NOVRAM and recalled and loaded
into current parameters when power is cycled to the imager or the
issued.
Defaults
Defaults are Microscan firmware settings or saved customer settings that can be recalled,
either by software or hardware reset.
QX Hawk Industrial Imager User's Manual
Function
Serial
ESP
Cmd
Save to Reader,
<A>
Send No Save
<Ard> Send <Ard> from Terminal
<Arp> Send <Arp> from Terminal
<Arc> Send <Arc> from Terminal
Save to Reader,
<Z>
Send and Save
Save to Reader,
<Zc> Send and Save Customer
Defaults for Power-On
<Zrd> Send <Zrd> from Terminal
<Zrc> Send <Zrc> from Terminal
Utilities
a
EZ Button
No
No
No
No
No
No
b
No
Press and
hold while
powering
on imager
<Arp> command is
7-23