Database Identifier Output - Microscan QX Hawk User Manual

I/O Parameters

Database Identifier Output

Useful in tracking which database entries read which symbols.
Database Identifier Output Status
Disabled
When this command is disabled, no database identifier information will be output.
Enabled
When this command is enabled, the imager will append a two-digit number and the characters
"DB" to the data output following the separator for each symbol decoded using Configuration
Database. For example, if the separator is an underscore character and the second database
entry reads a symbol encoded with "data capture" during the read cycle, the symbol data
output will be "data capture_DB02". If the database is not active, no identifiers will be
attached to output.
Separator Character
The separator character separates the symbol data from the database identifier.
5-122
QX Hawk Industrial Imager User's Manual