Table of Contents
Advertisement
I/O Parameters
No Read Message
Used in applications where the host needs serial verification that a symbol has not been
read and especially useful in new print verification.
When enabled, and if no symbol has been decoded before timeout or the end of the read
cycle, the No Read message will be transmitted to the host.
No Read Message Status
Disabled
Only symbol data is output after a read cycle.
Enabled
When the imager is in a triggered mode, a No Read message will be appended for each
failed read attempt.
Message
Any combination of ASCII characters can be defined as the No Read message.
Note: No Read Message will only be transmitted if
Mismatch, or Good Read. No Read Message can be set to any ASCII character.
5-96
Symbol Data Output
QX Hawk Industrial Imager User's Manual
is set to Match,
Advertisement
Table of Contents
Need help?
Do you have a question about the QX Hawk and is the answer not in the manual?
Questions and answers