Dhcp Relay Commands - D-Link xStack DES-6500 Cli Manual

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
The DHCP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config dhcp_relay
config dhcp_relay add ipif
config dhcp_relay delete ipif
config dhcp_relay option_82 state
config dhcp_relay option_82 check
config dhcp_relay option_82 policy
show dhcp_relay
enable dhcp_relay
disable dhcp_relay
Each command is listed in detail in the following sections.
config dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config DHCP relay:
Used to configure the DHCP/BOOTP relay feature of the Switch.
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>}
This command is used to configure the DHCP/BOOTP relay feature.
hops <value 1-16> Specifies the maximum number of relay agent
hops that the DHCP/BOOTP packets can cross. The range is from 1
to 16 hops, with a default setting of 4.
time <sec 0-65535> The minimum time, in seconds, in which the
Switch must relay the DHCP/BOOTP packet. If this timer expires, the
Switch will drop the DHCP/BOOTP packet. The default setting is 0.
Only Administrator-level users can issue this command.
DES-6500:4#config dhcp_relay hops 2 time 23
Command: config dhcp_relay hops 2 time 23
Success.
DES-6500:4#
DHCP R
Parameters
{hops <value 1-16> | time <sec 0-65535>}
<ipif_name 12> <ipaddr>
<ipif_name 12> <ipaddr>
[enable | disable]
[enable | disable]
[replace | drop | keep]
{ipif <ipif_name 12>}
294
33
C
ELAY OMMANDS