Dhcp Relay Commands - D-Link DES-3010F Command Line Interface Manual

Managed 8/16/24-port 10/100mbps n-way fast ethernet switch
Hide thumbs Also See for DES-3010F:
Table of Contents

Advertisement

The DHCP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config dhcp_relay
config dhcp _relay
config dhcp_relayoption_82
enable dhcp _relay
disable dhcp _relay
show dhcp _relay
config dhcp_relay
option_60 state
configure dhcp_relay
option_60 add
config dhcp_relay
option_60 default
config dhcp_relay delete
option_60
show dhcp_relay option_60
config dhcp_relay
option_61
config dhcp_relay
option_61 add
config dhcp_relay
option_61 default
config dhcp_relay
option_61 delete
show dhcp_relay option_61
Each command is listed, in detail, in the following sections.
config dhcp_relay
Purpose
Syntax
Description
Parameters
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
{ hops <value 1-16> | time <sec 0-65535>}
[add|delete] ipif <ipif_name 12> <ipaddr>
{ state [enable|disable] | check [enable|disable] | policy
[replace|drop|keep] }
{ipif <ipif_name 12>}
[enable|disable]
string <desc 255> relay <ipaddr> [exact-match|partial-
match]
[relay <ipaddr>| mode [drop|relay]]
[ string <desc 255> {relay <ipaddr>}| ipaddress < ipaddr
>|all |default {< ipaddr>}]
{[string <desc 255>| ipaddress < ipaddr>|default]}
state [enable|disable]
[mac_address <macaddr> |string <desc 255>] [relay
<ipaddr>| drop]
[relay <ipaddr>|drop]
[mac_address <macaddr> | string <desc 255>|all]
Used to configure the DHCP relay feature of the switch.
config dhcp_relay { hops <value 1-16> | time <sec 0-65535>}
The config dhcp_relay command configures the DHCP relay feature
of the switch.
hops <value 1-16> – specifies the maximum number of relay hops
that the DHCP/BOOTP packets can cross. The range is 1 to 16. The
default value is 4. The DHCP packet will be dropped when the relay
hop count in the received packet is equal to or greater than this
setting.
time <sec 0-65535> – the secs field in the DHCP packet must be
equal to or greater than this setting to be relayed by the router. The
default value is 0.
DHCP
53
8
C
RELAY
OMMANDS

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Des-3010gDes-3018Des-3026Des-3016Des-3010fl

Table of Contents