Arp Commands - D-Link DES-3010F Command Line Interface Manual

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
show arpentry
config arp_aging time
clear arptable
Each command is listed, in detail, in the following sections.
show arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the ARP table:
DES-3026:4#show arpentry
Command: show arpentry
ARP Aging Time : 20
Interface
-------------
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
{ipif <ipif_name 12> | ipaddress <ipaddr> | static}
<value 0-65535>
Used to display the ARP table.
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> |
static}
This command is used to display the current contents of the
Switch's ARP table.
<ipif_name 12> − The name of the IP interface the end node or
station for which the ARP table entry was made, resides on.
<ipaddr> − The network address corresponding to the IP interface
name above.
static − Displays the static entries to the ARP table.
None.
IP Address MAC Address
--------------- -----------------
10.0.0.0 FF-FF-FF-FF-FF-FF
10.1.1.169 00-50-BA-70-E4-4E
10.1.1.254 00-01-30-FA-5F-00
10.9.68.1 00-A0-C9-A4-22-5B
10.9.68.4 00-80-C8-2E-C7-45
10.10.27.51 00-80-C8-48-DF-AB
10.11.22.145 00-80-C8-93-05-6B
10.11.94.10 00-10-83-F9-37-6E
10.14.82.24 00-50-BA-90-37-10
10.15.1.60 00-80-C8-17-42-55
10.17.42.153 00-80-C8-4D-4E-0A
10.19.72.100 00-50-BA-38-7D-5E
10.21.32.203 00-80-C8-40-C1-06
10.40.44.60 00-50-BA-6B-2A-1E
10.42.73.221 00-01-02-03-04-00
10.44.67.1 00-50-BA-DA-02-51
10.47.65.25 00-50-BA-DA-03-2B
10.50.8.7 00-E0-18-45-C7-28
Type
---------------
Local/Broadcast
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
168
28
ARP C
OMMANDS