Arp Commands - D-Link DGS-3224TGR Command Line Interface Reference Manual

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config arp_aging
show arpentry
clear arptable
Each command is listed, in detail, in the following sections.
config arp_aging
Used to configure the age-out timer for ARP table entries on the switch.
Purpose
Syntax config arp_aging time <min 0-65535>
Description This command sets the maximum amount of time, in minutes, that a ARP entry can remain in
the switch's ARP table, without being accessed, before it is dropped from the table.
Parameters time <min 0-65535> − The ARP age-out time, in minutes. The default is 20.
Only administrator-level users can issue this command.
Restrictions
Example Usage:
To configure ARP aging time:
DGS-3224TGR:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
Parameters
time <min 0-65535>
{ipif(1) <ipif_name 12> | ipaddress(2) <ipaddr> | static(3)}
ARP C
58
12
OMMANDS