Arp Commands - D-Link DES-3010F Command Line Interface Manual

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
show arpentry
config arp_aging time
clear arptable
Each command is listed, in detail, in the following sections.
show arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the ARP table:
DES-3026:4#show arpentry
Command: show arpentry
ARP Aging Time : 20
Interface
---------
System
System
System
System
System
System
System
System
System
System
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
{ipif [System] | ipaddress <ipaddr> | static}
<value 0-65535>
Used to display the ARP table.
show arpentry {ipif [System] | ipaddress <ipaddr> | static}
This command is used to display the current contents of the
Switch's ARP table.
ipif [System]  The name of the IP interface, the end node or
station for which the ARP table entry was made, or resides on.
<ipaddr>  The network address corresponding to the IP interface
name above.
static  Displays the static entries to the ARP table.
None.
IP Address MAC Address
---------- -------------
10.0.0.0 FF-FF-FF-FF-FF-FF
10.1.1.169 00-50-BA-70-E4-4E
10.1.1.254 00-01-30-FA-5F-00
10.9.68.1 00-A0-C9-A4-22-5B
10.9.68.4 00-80-C8-2E-C7-45
10.10.27.51 00-80-C8-48-DF-AB
10.11.22.145 00-80-C8-93-05-6B
10.11.94.10 00-10-83-F9-37-6E
10.14.82.24 00-50-BA-90-37-10
10.15.1.60 00-80-C8-17-42-55
200
31
ARP C
OMMANDS
Type
----------
Local/Broadcast
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic