Arp Commands - D-Link xStack DES-6500 Cli Manual

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create arpentry
delete arpentry
show arpentry
show arpentry ipaddress
config arp_aging time
clear arptable
Each command is listed, in detail, in the following sections.
create arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
Parameters
<ipaddr> <macaddr>
[<ipaddr> | all]
{ipif <ipif_name 12> | static}
<ipaddr>
<value 0-65535>
Used to make a static entry into the ARP table.
create arpentry <ipaddr> <macaddr>
This command is used to enter an IP address and the corresponding
MAC address into the Switch's ARP table.
<ipaddr>  The IP address of the end node or station.
<macaddr>  The MAC address corresponding to the IP address
above.
Only Administrator-level users can issue this command.
DES-6500:4#create arpentry 10.48.74.121 00-50-BA-
00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-
07-36
Success.
DES-6500:4#
272
29
ARP C
OMMANDS