Chapter 11 Avaya P330 Layer 2 Features; Overview; Ethernet - Avaya P333T Installation & Configuration Manual

Chapter 11
Avaya P330 Layer 2 Features
This section describes the Avaya P330 Layer 2 features. It provides the basic
procedures for configuring the P330 for Layer 2 operation.

Overview

The P330 family supports a range of Layer 2 features. Each feature has CLI
commands associated with it. These commands are used to configure, operate, or
monitor switch activity for each of the Layer 2 features.
This section of the User's Guide explains each of the features. Specifically, the topics
discussed here include:
•

Ethernet

• VLAN
• Port Based Network Access Control
• Spanning Tree Protocol
• Rapid Spanning Tree Protocol
• MAC Security
• Link Aggregation Group (LAG)
• Port Redundancy
• IP Multicast Filtering
• Stack Health
• Stack Redundancy
• Port Classification
Ethernet
Ethernet is one of the most widely implemented LAN standards. It uses the Carrier
Sense Multiple Access with Collision Detection (CSMA/CD) access method to
handle simultaneous demands. CSMA/CD is a multi-user network allocation
procedure in which every station can receive the transmissions of every other
station. Each station waits for the network to be idle before transmitting and each
station can detect collisions by other stations.
The first version of Ethernet supported data transfer rates of 10 Mbps, and is
therefore known as 10BASE-T.
Avaya P333T User's Guide 57