Inspect The Engine Air Filter - Ford, Deutz And Perkins Models; Check The Oil Cooler And Cooling Fins - Deutz Models - Genie S-60 TraX Service Manual

December 2013
B-4
Inspect the Engine Air Filter -
Ford, Deutz and Perkins Models
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
Note: Perform this procedure with the engine off.
1 Locate the engine air filter assembly.
2 Release the latches from the air cleaner canister
end cap. Remove the end cap.
3 Remove the filter element.
4 Clean the inside of the canister and the end cap
with a damp cloth.
5 Inspect the air filter element. If needed, blow
from the inside out using low pressure dry
compressed air, or carefully tap out dust.
Replace the filter if needed.
6 Install the filter element.
7 Install the air filter canister end cap and secure
the end cap latches.
Note: Be sure the discharge valve is pointing down
when the cap is installed.
Part No. 147753
B-5
Check the Oil Cooler and
Cooling Fins - Deutz Models
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Maintaining the oil cooler in good condition is
essential for good engine performance. Operating a
machine with a damaged oil cooler may result in
engine damage. Also, restricting air flow through
the oil cooler will affect the performance of the
cooling system.
Oil cooler:
1 Remove the engine tray retaining fastener
2 Install the fastener that was just removed
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
Bodily injury hazard. Do not
inspect while the engine
is running. Remove the key to
secure from operation.
Burn hazard. Beware of hot engine
components. Contact with hot
engine components may result in
severe burns.
located under the engine tray. Swing the engine
tray out and away from the machine.
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
3 - 23