Genie S-60 TraX Service Manual page 103

December 2013
7 Tag, disconnect and plug the two suction hoses
and supply hose for the auxiliary pump from the
hydraulic tank. Cap the fittings on the tank.
Note: The hoses can be accessed through the
access hole under the turntable.
8 Disconnect and plug the return filter hydraulic
hose at the return filter. Cap the fitting on the
filter housing.
9 Remove the ground controls side turntable
cover.
10 Support the hydraulic tank with an appropriate
lifting device.
11 Remove the hydraulic tank mounting fasteners.
12 Remove the hydraulic tank from the machine.
Crushing hazard. The hydraulic
tank could become unbalanced
and fall if not properly supported
when removed from the machine.
13 Remove the hydraulic return filter housing
mounting fasteners. Remove the hydraulic
return filter housing from the hydraulic tank.
14 Remove the suction strainers from the tank and
clean them using a mild solvent.
15 Rinse out the inside of the tank using a mild
solvent.
16 Install the suction strainers using a thread
sealant on the threads.
17 Install the drain plug using a thread sealant on
the threads.
Part No. 147753
18 Install the hydraulic return filter housing onto the
19 Install the hydraulic tank onto the machine.
20 Install the two suction hoses to the suction
21 Install the supply hose for the auxiliary power
22 Open the two hydraulic tank valves at the
23 Fill the tank with hydraulic oil until the level is
24 Clean up any oil that may have spilled.
25 Prime the pump. Refer to Repair Procedure 6-2,
Note: Always use pipe thread sealant when
installing the suction hose fittings and the drain
plug.
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Section 3 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
hydraulic tank.
strainers.
unit and the return filter hose.
hydraulic tank.
within the top 2 inches / 5 cm of the sight
gauge. Do not overfill.
How to Prime the Pump.
3 - 65