Grease The Turntable Rotation Bearing And Rotate Gear - Genie S-60 TraX Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
2 Loosen the low idle lock nut and turn the low idle
adjustment screw clockwise to increase the
rpm, or counterclockwise to decrease the rpm.
Tighten the low idle lock nut and confirm the
rpm.
a b
a solenoid boot
b high idle adjustment nut
c yoke
d low idle lock nut and adjustment
screw
3 Move the function enable toggle switch to the
high idle (rabbit symbol) position and note the
rpm. Refer to Section 2, Specifications .
If high idle rpm is correct, disregard adjustment
step 4.
4 Loosen the yoke lock nut, then turn the high idle
adjustment nut and solenoid boot
counterclockwise to increase the rpm or
clockwise to decrease the rpm. Tighten the
yoke lock nut and recheck the rpm.
Note: Be sure the solenoid fully retracts when
activating high idle.
3 - 16
c d
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
A-13
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that this procedure be
performed every 100 hours of operation. Perform
this procedure more often if dusty conditions exist.
Frequent application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an improperly greased bearing and gear will
result in component damage.
1 Locate the grease fitting on the front turntable
cover.
2 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of 4 to 5
inches / 10 to 13 cm at a time and repeat this
step until the entire bearing has been greased.
3 Apply grease to each tooth of the drive gear,
located under the turntable.
Grease Specification
Chevron Ultra-duty grease, EP NLGI 2 (lithium based)
or equivalent
December 2013
Part No. 147753