Section 4 • Repair Procedures
TRACK COMPONENTS
21 Continue to pump grease into the cylinder until
the track has proper tension.
Component damage hazard.
Do not over tighten the track.
Overtightening the track will cause
the machine to lose power during
operation.
Note: If the track becomes too tight, loosen the
grease plug on the cylinder to remove grease and
loosen the track.
22 Raise the machine, remove the jack stands and
lower the machine.
23 Drive the machine in either direction just until
the remaining sprocket retaining fasteners can
be installed onto the drive hub adapter. Turn the
machine off.
24 Install the remaining sprocket retaining fasteners
to the drive hub adapter and torque to
specification. Refer to Section 2, Specifications .
Grease Specification
Chevron Ultra-duty grease, EP NLGI 2 (lithium based)
or equivalent.
4 - 74
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
December 2013
Part No. 147753