Genie S-60 TraX Service Manual page 87

December 2013
9 Clean up any diesel fuel that may have spilled
during the installation procedure.
10 Install the fuel supply hose from the fuel tank to
the fuel filter/water separator. Tighten the
clamp.
11 Use a permanent ink marker to write the date
and number of hours from the hour meter on the
oil filter housing.
Bleed the system:
12 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
13 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
14 Loosen the vent plug on top of the fuel injection
pump.
c
a vent plug
b fuel injection pump
c fuel lift pump
Part No. 147753
15 Operate the priming lever or priming bulb (if
16 Clean up any fuel that may have spilled during
17 Operate the starter motor for intervals of 15
Note: It is important to allow the starter motor to
cool for 30 seconds between each 15 second
interval of operation.
Note: If the engine runs correctly for a short time
and then stops or runs roughly, check for air in the
fuel system. If there is air in the fuel system, there
is probably a leak in the low pressure side of the
system.
18 Swing the engine back to its original position
a
b
S-60 • S-65 • S-60 TRAX • S-65 TRAX
S-60 HC • S-60X • S-60XC
Section 3 • Scheduled Maintenance Procedures
CHECKLIST C PROCEDURES
equipped) of the fuel lift pump until fuel, free
from air, comes from the vent plug. Tighten the
vent plug.
this procedure.
seconds until the engine starts.
and install the engine pivot plate retaining
fastener.
3 - 49